Ironing a blazer means accounting for its lapels, shoulders, lining and shaped front. Not every raised area is a wrinkle. Before applying the iron, check the care label and additional manufacturer instructions, then identify the section that actually needs smoothing.
Identify the area that needs attention
Inspect the blazer from the front, back and inside. Distinguish a storage crease from the line of a lapel, dart or shaped shoulder. If the problem concerns construction rather than a single surface wrinkle, do not try to reshape the whole component through home ironing. Photograph the problem and seek guidance on correcting it.
Position one section without tension
Empty the pockets and check that lining or a pocket bag has not folded beneath the work area. Support the rest of the blazer so it does not pull on the section being treated. Do not stretch the joins between lining and outer fabric. Move buttons and other raised components away from the surface over which the iron would pass.
Preserve the lapel and shoulder lines
Check the lapel’s natural position before rearranging it. Do not treat it like a flat trouser leg where you want to set a new crease. Assess the shoulder and sleeve head in the same way: their shape belongs to the blazer’s construction. If you are unsure how to support a component, leave it for assessment by someone experienced in pressing structured garments.
Check the result before another pass
Use only settings and surface protection permitted for this blazer. Check colour, texture and sheen after a small section. A surface change is a reason to stop. Finally, compare both sides of the front and check that the lining sits freely. A pulling seam or uneven lapel may require tailoring rather than more steam.